Dell c6420 how to#

Read the Ethernet MAC address of the desired port.Ĭhange Boot Sequence: NIC, then Hard drive C:Ĭ6400 Chassis System Management  Front control panel LED colors  The following procedure has been tested with BIOS 1.6.11 and iDRAC9 firmware 3.21:ĭuring system boot press F2 to go to System Setup. The server Ethernet port must do PXE boot before hard disk boot. Server Ethernet port in port 2 of 10 Gbit mezzanine card. Our network configuration is designed to be: The C6420 factory default network settings has the iDRAC9 port shared with a 1 Gbit LOM Ethernet port. Select the Legacy Boot Protocol item PXE.Ĭlick the Boot Sequence item to move PXE boot up above the hard disk boot.

Read the NIC Ethernet MAC Address from this page for configuring the DHCP server. We use NIC port 3 (1 Gbit) as the system’s NIC. In the NIC Main Configuration Page select NIC Configuration. Go to the System Setup menu item Device Settings and select the Integrated NIC items: In the System Summary page read the NIC iDRAC MAC Address from this page for configuring the DHCP server. The Dell iDRAC9 (BMC) setup is accessed via the System Setup menu item iDRAC Settings: Remaining settings will be configured by racadm (see the Dell R640 server page). Minimal configuration of a new server or motherboard Īt our site the following minimal settings are required for a new server or a new motherboard.

Dell c6420 how to#

See How to inspect and change BIOS configurations on a PowerEdge C-Series server with SetupBIOS tool.

Press F2 during start-up to enter the BIOS and firmware setup menus. Documentation and software ĭownload the OpenManage software ISO image from the C6420_downloads page in the Systems Management download category. This page contains information about Dell PowerEdge C6420 servers deployed in our cluster. Minimal configuration of a new server or motherboardĭisk firmware upgrade without RAID controller